A6 6-Channel Power AmplifierDesigned specifically for the custom installer, the A6 power amplifier is the cornerstone of any high-fidelity system. The A6 provides six channels at 60 WPC or three channels at 120 WPC in a 1.75" single rack space—plus additional features not found on any other amplifier (of any size) on the market today.
Six front panel gain pots, signal presence and clip indicators make setup a snap! A convenient Bus Mode switch allows one stereo input to be routed to all three pairs of amplified outputs without the need for additional patch cables.
Independent Bridge Mode buttons allow mixing of bridged and un-bridged channels. Buffered line level outputs can be Y-corded for mono signal applications.
The built-in IR connecting block can power up to four IR receivers and emitters—great for standalone IR control applications! The remote trigger input mutes the amplifier when the preamp is turned off.
| 60 WPC RMS into 8 Ohms 120 WPC RMS into 8 Ohms, bridged |
| Front panel gain pots, signal presence, clip & IR pass-through LED indicators |
| Bus Mode switch |
| Buffered line level outputs |
| IR pass-through connecting block |
| Remote trigger IN/OUT |
| Only 1 rack-space high |
| Frequency Response |
20Hz to 20kHz -.25dB |
| Full Power Bandwidth |
10Hz to 30kHz |
| Signal to Noise |
>110dB (A-weighted) |
| Channel Separation |
>70dB @ 1kHz |
| THD |
< 0.03% |
| Intermodulation Distortion |
< -90dB |
| Voltage Gain (Av) |
0 to 28, adjustable |
| Input Impedance |
20k Ohms |
| Remote Trigger Input |
5-24V AC/DC |
| Trigger Loop Output |
+12VDC @ 0.1A |
| AC Power Requirements |
120VAC, 440W |
| Current Draw |
3.7A @ 120VAC |
| A6 Dimensions |
(in.) 17 W x 2-1/4 H x 11 D, (mm) 432 W x 58 H x 280 D |
| A6 Dimensions |
(in.) 19 W x 1-3/4 H x 11 D, (mm) 483 W x 45 H x 280 D |
| Weight |
16 lbs/7.2 kg |
| ETL® listed & CE approved |
